Dodge Dtc P0871 - do3

For the '04 dodge intrepid, dtc p0871 indicates od pressure switch sense circuit.

You should have 6.

While pulling my toy hauler (about 8k lbs empty and almost 16k fully loaded) last week i got the dreaded p0871 code.

P0871 is an od pressure switch rationality fault, which means the od pressure switch was in the wrong state (open when it should be closed, or closed when it should be open).

This code is triggered when the oxygen sensor on bank 1, sensor 1 detects a consistently rich fuel mixture.

Mil illumination for dtc's p0750, p0755, p0760, p0765, p0846, p0871 or p0841 overview:

P0871 is an od pressure switch rationality fault, which means the od pressure switch was in the wrong state (open when it should be closed, or closed when it should be.

Back in march, i started experiencing shifting problems and it popped a code for the p0871,.

Your dodge coronet engine control system detects a problem, the computer stores the diagnostic trouble code p0871 in its memory.

How to fix the dtc p0871 dodge?

That could be the p0841 or another transmission.

Just came off the highway previously.

I spoke with a local transmission shop and was told that.

On climbing a small grade,.

Hi, i'm getting these codes on my dodge durango 2009 (p0846, p0988, p0871, p0876), i recently changed the battery, the transmission fluid is kind of in a bad condition but.

The following tsbs of dodge are related to dtc p0871.

The possible causes for this dtc to set are :

Ensure to check for.

Driving around yesterday and the check engine cel popped up on the evic.

P0841 is for the low/reverse pressure switch in the solenoid pack mounted on the front of the.

If you’re experiencing the p0871 code in your dodge ram 2500, it’s important to evaluate the severity of the issue before deciding whether to seek professional help.

This is a block of data that gets written into memory in the pcm whenever a trans fault is set (and shows what was happening at the moment the fault set).

I’ve read posts about the p0871 code but i can’t seem to find one with the fix.

Review the 'possible causes' mentioned above and visually examine the corresponding wiring harness and connectors.

If 90k+, then you likely have a worn solenoid switch valve.

This could mean that there is too much pressure inside of the transmission or.

The output is commanded on, the dtc will set.

It's a 2016 ram 2500 6. 4 liter and 6 speed 66rfe transmission.

📸 Image Gallery

Report a problem with this article.

This bulletin involves replacing the transmission solenoid/pressure switch.

Click to display a list of tools used in this procedure.

How many miles on your truck?

P0871 is an od pressure switch rationality code, and is typically caused by either a worn solenoid switch valve (ssv) bore in the main valve body, or by a bad wiring.

The p0700 is telling you the transmission control module or tcm has detected and stored a transmission fault code.

2004 dodge dakota electrical.

To figure out what is wrong with your vehicle you must first.

Inadequate transmission control output voltage can also cause dtcs p0846, p0869, p0871, p0876 or p0988 to set.

Answered in 5 minutes by:

Related relay dtc's present.

In some cases, the.

Mine either happens when pulling a trailer and getting.

I’m trying to keep from throwing parts at it.

Hello and welcome to justanswer!

For a complete wiring diagram, refer.